Konica Minolta Ultra KDR Configuration And Calibration Manual
  1. Manuals
  2. Brands
  3. Konica Minolta Manuals
  4. Medical Equipment
  5. Ultra KDR
  6. Configuration and calibration manual

Konica Minolta Ultra KDR Configuration And Calibration Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Ultra KDR
Configuration and
Calibration Guide

Advertisement

Table of Contents
loading

Related Manuals for Konica Minolta Ultra KDR

Summary of Contents for Konica Minolta Ultra KDR

  • Page 1 Ultra KDR Configuration and Calibration Guide...

  • Page 2: Table Of Contents

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra Contents KDR Panel Registration, Configuration and Calibration ..................3 Before you begin ..........................3 Configuring the KDR panel ........................4 Panel Registration ..........................4 1.3.1 Before you begin .......................... 4 1.3.2 Panel registration .........................

  • Page 3: Kdr Panel Registration, Configuration And Calibration

    KDR Panel Registration, Configuration and Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra Calibration This section describes the configuration of the KDR panel in Ultra software. 4. Set the following addresses: 1.1 Before you begin For Panel Specification, Safety Information and Handling instructions IPV4 address: 192.168.20.100...

  • Page 4: Configuring The Kdr Panel

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 1.2 Configuring the KDR panel 1.3 Panel Registration 1. In Ultra, select the Device Configuration tab. 1.3.1 Before you begin 2. Under the Configuration Pool section, select You will need to power on the KDR panel and have Default, then select KDR (Figure 3).

  • Page 5: Panel Registration

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 1.3.2 Panel registration 4. Click Manual Registration to launch the 1. Launch Ultra. Konica Minolta Aero SDK Setting Tool For detailed Ultra software information refer to Ultra DR (Figure 7). Quick Guide and or the Ultra UAI Admin Guide.
  • Page 6 Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 5. Click Add IF Cable. (Figure 8) 9. On the KONICA MINOLTA AeroSDK Setting Tool main screen, click Add Panel (Figure 9). Figure 8 AeroSDK Setting Tool – IF Cable Registration...

  • Page 7: Panel Configuration

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 13. Click Ok. 2. Click OK to start the installation. The following window is displayed (Figure 3. After installation is complete, click OK. 12). At this time disconnect and reconnect You are returned to the KONICA MINOLTA the IF cable on the panel side.

  • Page 8: Verify Successful Panel Configuration

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 1.3.4 Verify successful panel configuration 1.4 KDR Panel Calibration 1. Launch Ultra. 1.4.1 Before you begin 2. Select a test patient. 1. Remove the grid. 3. Click Acquire to open the acquisition 2.

  • Page 9: Verify Calibration

    Ultra KDR Panel Configuration and Calibration Guide v1.1 Ultra 8. At the Please input panel Id:  prompt, 15. If the “Recommended Technique” is low or type the Panel Serial Number listed on the high. The application will prompts you to back of the panel.

Table of Contents