Konica Minolta REGIUS 190 Service Manual page 184

Error Error name
code
Lock start NG
04162
Back plate detect time
04163
NG
Notice for erase lamp
04164
ON not reached
04165 Notice for erase lamp
OFF not reached
Error description
Push-up operation could not be
carried out by the lock motor as a
result of a problem in the firm-
ware.
The eject shutters closed before
the delay time for cassette
descent detection had elapsed
from the start of elevation-section
rise during ejection. The delay
time for cassette descent detec-
tion is too short.
The timing for switch-On of the
erasure lamp during erase opera-
tion by the subscanning section
was not reported in either Read
mode or Erase mode.
The timing for switch-Off of the
erasure lamp during erase opera-
tion by the subscanning section
was not reported in either Read
mode or Erase mode.
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Action
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
4.4 Error Code
157