2.4 Transport Unit
11.
Remove the remaining fixing screws (2pcs), and detach the
rack gear holder pad (left).
12.
Remove a fixing screw, and remove the transport rack gear
on the left.
13.
Install a new transport rack gear on the right sector plate
with two fixing screws.
14.
Install the rack gear holder pad on the right sector plate with
three fixing screws.
•
Lubrication after installation
Lubricate the pinion gear on the transport rack gear with a
small quantity of grease.
Recommended Grease: Kyodo Yushi Co., Ltd. Plus Guard No.2
or equivalent.
•
Adjustment after installation
Carry out
"3.7 Adjusting the Pressing Amount, p.122"
58
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Rack Gear Holder Pad (Left)
Fixing Screw
Transport Rack Gear (Left)
Fixing Screw