2.7 Electrical Unit
6.
Remove a fixing screw, and pull out the MCB2 from board's
support legs (5pcs).
7.
Carry out reassembly in the reverse order to that described
above.
•
Remarks for Installation
•
Set the rotary SW (SW4) and DIP SW (SW3) on the new
board according to the note taken in step 3.
•
Check that the DIP SW(SW2)'s all dips are set to OFF
(set to the left) before turning on the power.
•
Update the firmware using the REGIUS Console.
82
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Fixing Screw
Board's Support
Legs
MCB2
SW2