Konica Minolta REGIUS 190 Service Manual page 15

Disposing of the system
Disposal must be carried out in accordance with local ordinances and regulations.
The replaceable REGIUS plates used in REGIUS cassettes are coated with fluorescent material
that has toxic potential. Disposal and replacement of these plates must be carried out by properly
trained service personnel.
<IMPORTANT>Should this manual become not readable due to any reason, replace it with a new one
which is available at charged basis.
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
viii
4. When using the equipment, observe the following precautions.
(1) Be careful not to exceed the time period and the amount of X-rays
required for diagnosis or treatment.
(2) Always monitor the entire equipment and a patient for safety.
(3) If an abnormality occurs on the equipment or a patient, take appropriate
measures (i.e. turn off the equipment ensuring the safety for patient, etc.),
to ensure patient protection.
(4) Do not allow a patient to touch the equipment.
5. After using the equipment, observe the following precautions.
(1) Return the switches and dials to their original positions in the specified
procedure, and turn the equipment OFF.
(2) When disconnecting the cables, do not pull the cables or apply an exces-
sive force to them.
(3) Observe the following precautions concerning the storage location.
• Store the equipment in a location where it is not exposed to water.
• Store the equipment in a location where there is no likelihood of being
adversely affected by atmospheric pressure, temperature, humidity,
drafts, light, dust, or air containing salt, or sulfur, etc.
• Store the equipment in a stable location. Do not store it on an inclined
surface and avoid vibrational shock (including during transportation).
• Do not store the equipment in a location where chemical reagents are
stored or where chemical fumes may be present.
(4) Keep all accessories, cables, terminals, etc. neatly after cleaning them.
(5) Be sure to keep the equipment clean for next use.
6. In the event that the equipment operates incorrectly or breaks down,
do not try to repair it yourself. Have a trained engineer to repair it.
7. Never attempt to modify the equipment.
8. Maintenance and Inspection
(1) Inspect the equipment and its components regularly.
(2) If the equipment has not been used for an extended period of time, clean
the equipment and make sure it operates safely before using it.
9. Operate the equipment correctly according to the Operation Manual.