Konica Minolta REGIUS 190 Service Manual page 180

Error Error name
code
Justification sensor-L
04027
NG (at initializing)
Cassette Receive
04031
Sensor NG (at read-
ing)
Cassette Receive
04032
Sensor NG (at
adsorption)
Cassette Receive
04033
Sensor NG (during
escape)
Cassette Receive
04034
Sensor NG (at ejec-
tion before elevation)
Lock-Release sensor
04035
NG
04036 Elevator HP sensor
NG
Error description
The right side of the Justification
Sensor was ON after completion of
HP motion processing for initializa-
tion by the justification.
1) The elevation-bed cassette
sensor was OFF after the com-
pletion of width-justification
motion during cassette take-in.
2) The elevation-bed cassette
sensor was OFF after closing of
the insertion slot shutter during
cassette take-in.
1) The elevation-bed cassette
sensor was OFF after comple-
tion of motion to the absorption
position by the transport unit
during cassette absorption.
2) The elevation-bed cassette
sensor was OFF after lock
release during cassette absorp-
tion.
3) The elevation-bed cassette
sensor was OFF after the com-
pletion of motion by the trans-
port unit to the absorption
position during cassette ejec-
tion.
1) The elevation-bed cassette
sensor was OFF after the com-
pletion of motion by the trans-
port unit to the Escape Position
following cassette separation.
2) The elevation-bed cassette
sensor was OFF after the com-
pletion of erasure.
The elevation-bed cassette sen-
sor was OFF after the completion
of motion by the transport unit to
the eject position during cassette
ejection.
A time-out occurred for ON or OFF
detection by the lock HP sensor
during lock or unlock operation.
A time-out or limit-over occurred
for ON detection by the HP sensor
during HP motion processing by
the elevation bed.
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Action
• Check MCB2:CN11-, pins 9 through
11 (Justification Sensor- L)
• Check no foreign object is present in
the justification guide-L
• Check MCB2:CN11-, pins 6 through
8 (Cassette Receive Sensor)
• If the error occurred with small size
cassette, reset the device to READY
by performing open/close of front
cover
Check MCB2:CN11-, pins 6 through 8
(Cassette Receive Sensor)
Check MCB2:CN11-, pins 6 through 8
(Cassette Receive Sensor)
Check MCB2:CN11-, pins 6 through 8
(Cassette Receive Sensor)
• Check MCB2:CN11-, pins 3 through
5 (lock HP sensor) and MCB2:CN11-
, pins 1 and 2 (Lock Release Motor)
• Check the plu ger pin is actuating. if
it is not smoothly action ig, replace
the cassette receive unit. (p.54)
Check MCB2:CN11-, pins 26 through 28
(Elevator HP sensor) and MCB2:CN16
(Elevator Motor)
4.4 Error Code
153