Showing logging
About this task
You can display log messages for your switch.
Procedure
1. At the ACLI command prompt, enter the show logging command to display
2. Review the command output for mismatch information.
Correcting mismatches
About this task
You can configure the VRRP interface to eliminate the mismatch.
Procedure
1. At the ACLI command prompt, enter the command ip vrrp interface to
2. Review the command output for errors.
VR is stuck in the backup state when it should be the master
and no master is present
When the VR that should be the master is stuck in the backup state and no master VR is
present, you must configure a master VR.
Work flow: VR is stuck in backup state when it should be the master
and no master is present
You can use the following work flow to help determine what to do when a VR is stuck in the
backup state, when it should be the master, and no master is present.
Troubleshooting
VR is stuck in the backup state when it should be the master and no master is present
device log messages.
configure the interface.
December 2013
211