Avaya 5000 Series Troubleshooting Manual page 166

Troubleshooting layer 2 and layer 3
2. Review the command output to verify the timer information.
Showing IP OSPF interface statistics mismatch
About this task
Use the command in the following procedure to discover IP OSPF interface statistics
mismatches.
Procedure
1. At the ACLI command prompt, enter the show ip ospf ifstats mismatch
2. Review the command output for mismatched parameters.
Configuring matching values between neighbor routers for hello and dead
interval
Before you begin
• Access the ACLI VLAN Interface Configuration mode (at the command prompt type
enter, type configuration terminal, type int vlan <number>)
About this task
You must configure the same hello and dead-iInterval values for neighbor routers.
Procedure
1. At the VLAN Interface Configuration prompt, enter ip ospf hello-interval
2. At the VLAN Interface Configuration prompt, enter ip ospf dead-interval
3. Follow the vendor documentation to configure the neighbor router with the
166 Troubleshooting
command.
<number> to configure the hello interval.
Example
Set the hello interval to 10: ip ospf hello-interval 10
<number> to configure the dead interval.
Example
Set the dead interval to 40: ip ospf dead-interval 40
parameters from the preceding steps.
Comments? infodev@avaya.com
December 2013