Troubleshooting layer 2 and layer 3
Creating Static ARP entries in ACLI or EDM
About this task
Use the following procedures to create static ARP entries in ACLI and EDM.
Creating static ARP entries using ACLI
Procedure
1. Enter the Global Configuration mode in ACLI.
2. At the prompt, type the ip arp <a.b.c.d> <h.h.h> <unit/port> <vid>
Creating static ARP entries using EDM
Procedure
1. In EDM, select IP Routing > IP > ARP.
2. Enter the values required and press the Insert button.
Deleting an ARP entry using SNMP
About this task
You can use SNMP to remove individual ARP entries.
Procedure
1. Set the corresponding ipNetToMediaType to value "2" .
2. Review the display to ensure that the entry was removed.
Setting objects with SNMP
About this task
SNMP objects for IP Net to Media can be set if required.
Procedure
1. Use the SNMP set command on the ipNetToMediaIfIndex object.
2. Use the SNMP set command on the ipNetToMediaPhysAddress object.
144
Troubleshooting
command to create the static ARP entry.
Comments? infodev@avaya.com
December 2013