Procedure
1. At the ACLI command prompt, enter the show ip ospf interface vlan 2
2. Access the ACLI VLAN Interface Configuration mode as follows:
3. At the ACLI VLAN Interface Configuration mode prompt, enter the ip ospf
4. At the ACLI VLAN Interface Configuration mode prompt, enter the ip ospf
Configure router priority
You must verify that the interfaces of all routers do not use a router priority of 0.
At least one router must use a router priority of 1 or greater so that it can become the
Designated Router (DR) for the network.
Task flow: Configure router priority
You can use the following task flow to help change the router priority so that at least one has
a priority higher than zero.
Troubleshooting
command to verify that OSPF is not enabled on the interface.
a. At the ACLI command prompt, enter configure terminal.
b. At the ACLI command prompt, enter int vlan 2.
network broadcast command to change the type to broadcast.
enable command to enable OSPF.
Failure to establish OSPF adjacency
December 2013
173