Configure An Interface To Broadcast - Avaya 5000 Series Troubleshooting Manual

Showing an IP OSPF interface statistics mismatch
About this task
You can display the statistics for mismatched OSPF parameters.
Procedure
1. At the ACLI command prompt, enter the show ip ospf ifstats mismatch
2. Review the command output for mismatched OSPF parameters.
Configuring Area IDs
About this task
Use the following procedure to configure the Area IDs to match.
Procedure
1. At the ACLI command prompt, enter the show ip ospf ifstats command to
2. Use the following commands to access the OSPF Router Configuration ACLI
3. At the ACLI command prompt, enter network <ip> area <A.B.C.D> to set the

Configure an interface to broadcast

If you configure an interface to be passive it does not send hello to its connected neighbors,
or process hello from connected neighbors. OSPF interfaces are, by default, of the broadcast
type.
Task flow: Configure an interface to broadcast mode
You can use the following task flow to help configure an interface to broadcast mode.
Troubleshooting
command.
identify which area has an incorrect area attached.
command mode.
a. At the ACLI command prompt, enter enable.
b. At the ACLI command prompt, enter configure terminal.
c. At the ACLI command prompt, enter router ospf.
area ID
Failure to establish OSPF adjacency
December 2013 171