3. Use the SNMP set command on the ipNetToMediaNetAddress object.
4. Use the SNMP set command on the ipNetToMediaType object.
Confirming NVRAM file size
About this task
Use the information and procedure in this task to ensure that the NVRAM file size conforms to
the correct parameters.
Prerequisites:
• The
NVRAM:/APPS/staticarp.cfg
• File size is
- 8 byte header
- 20 byte record for each ARP
Procedure
1. Enter the dbg enable command.
2. Enter the dbg ll APPS command.
Rebooting the device to restore static ARP
About this task
You can reboot the device to restore the static ARP entries.
Procedure
1. Reboot the device.
2. Ensure that the device has rebooted correctly.
Configure ARP timeout
This section provides tasks and procedures that you can use to change the ARP timeout
value.
Troubleshooting
ARP not forwarding traffic correctly
file is stored
December 2013
145