Troubleshooting layer 2 and layer 3
Configuring the peer update interval
Before you begin
• The switch must be in the ACLI RIP Router configuration mode
About this task
Use the following procedure to configure the peer update timeout interval.
Procedure
1. From the ACLI RIP Router configuration mode command prompt, enter the timers
2. At the RIP Router configuration mode command prompt, enter the show ip rip
RIP routes learned with increasing cost
In some unstable networks with potential loops, routes are learned with increasing cost (until
16) even though the actual route is gone.
Work flow: RIP routes learned with increasing cost
You can use the following work flow to help determine the solution for RIP routes that continue
to be learned with an increasing cost.
190
Troubleshooting
basic update 10 command to change the update settings.
To access the ACLI RIP Router configuration mode do the following:
a. At the ACLI User EXEC command prompt, enter enable to access the
Privileged EXED command mode.
b. At the command prompt, enter configure terminal to access the
Global Configuration command mode.
c. At the command prompt, enter router rip to access the RIP Router
configuration mode.
command to review the current settings in the command output.
Comments? infodev@avaya.com
December 2013