Troubleshooting layer 2 and layer 3
Figure 106: Configure preempt action
Showing verbose IP VRRP interface information
About this task
You can verify critical information for the VRRP interface.
Procedure
1. At the ACLI command prompt, enter the command show ip vrrp interface
2. Review the command output to verify that
216
Troubleshooting
verbose.
• the VR is not in the hold-down state
• the corresponding VLAN is up
• the critical IP feature is enabled
• the critical IP address is set to one of the local L3 VLAN IP addresses
Comments? infodev@avaya.com
December 2013