Avaya 5000 Series Troubleshooting Manual page 163

Procedure
1. At the ACLI command prompt, enter the show ip ospf int-auth command to
2. Review the command output to verify the authentication methods.
Showing IP OSPF authentication for the interface VLAN
About this task
Use this procedure to display the assigned MD5 IDs and keys.
Procedure
1. At the ACLI command prompt, enter the show ip ospf authentication
2. Review the command output to verify the information.
Showing IP OSPF interface statistics mismatch
About this task
Use this procedure to display statistics for mismatched OSPF parameters.
Procedure
1. At the ACLI command prompt, enter the show ip ospf ifstats mismatch
2. Review the command output to verify the two mismatch counters, type and fail.
Configuring key identifier and value
Before you begin
• Open the ACLI VLAN interface configuration mode (at the ACLI command prompt enter
enable, enter configure terminal, enter int vlan <number>),
About this task
Both the key identifier and value must be matched.
Troubleshooting
display the IP OSPF interface authentication method.
interface vlan <vid> command to display the MD5 IDs and keys.
command to display the mismatch counters.
Failure to establish OSPF adjacency
December 2013 163