Avaya 5000 Series Troubleshooting Manual page 168

Troubleshooting layer 2 and layer 3
Figure 79: Configure MTU sizes
Showing IP OSPF interface VLAN
About this task
Use the following procedure to display the VLAN configuration for each interface OSPF
configuration.
Procedure
1. At the ACLI command prompt, enter the show ip ospf interface vlan
2. Review the command output to verify that the MTU is set to Ignore as follows:
168 Troubleshooting
<vid> command.
MTU Ignore: Yes
Comments? infodev@avaya.com
December 2013