Avaya 5000 Series Troubleshooting Manual page 189

Showing IP RIP interface timeout intervals
About this task
Use the following procedure to display the IP RIP interface information to observe the timeout
intervals.
Procedure
1. At the ACLI command prompt, enter the show ip rip interfacecommand.
2. Review the command output to observe the timeout intervals.
Configuring the timeout interval
Before you begin
• The switch must be in the ACLI RIP Router configuration mode
About this task
Use the following procedure to correct the learning and relearning behavior by configuring the
timeout interval.
Procedure
1. Access the ACLI RIP Router configuration mode.
2. At the command prompt, enter the timers basic timeout 30 command to
3. At the command prompt, enter the show ip rip command to review the current
Troubleshooting
To access the ACLI RIP Router configuration mode from the User EXEC
configuration mode do the following:
a. At the command prompt, enter enable.
b. At the Privileged EXEC command mode prompt, enter configure
terminal.
c. At the Global Configuration command mode prompt, enter router rip.
change the timeout settings.
settings in the command output.
RIP routes are learned then deleted and relearned
December 2013 189