Switch Led State Indicators - Avaya VSP 4450GSX-PWR+ Installing

1. USB 2.0 port
2. Switch LEDs
3. 10/100/1000 Base TX RJ-45 ports with PoE+ (LEDs above ports)
4. 100/1000 Mbps SFP ports
5. 1/10G SFP + ports
6. Console Port
Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber-optic cables are connected to a light
source.

Switch LED state indicators

The following figure describes the main switch LED state indications provided by LED color and
fluctuation cues.
Note:
Indicator states are applicable to all models of VSP 4000 switches.
Table 14: Switch LED state indicators
Label Color and Status
PWR Green (solid)
Off
Status Green (solid)
Green (blinking)
Amber (solid)
Amber (blinking)
Off
RPS Green (solid)
November 2016
Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
Description
The switch is receiving power either from the primary or
secondary power supply. Normal operation.
The switch is not receiving power and not operating.
• During start-up: The power-on self-test (POST) is complete
and the switch is operating normally.
• After start-up: The switch is running the agent code
successfully.
The switch is loading the agent software code.
The switch encountered an error when running the diagnostic
software.
The switch is booting and running diagnostic software. Normal
activity during boot process.
The switch failed the power-on self-test (POST) or failed to load
the agent code.
The switch is connected to a redundant power supply unit
(RPS) or a secondary external power supply, and is operating
normally.
Installing Avaya Virtual Services Platform 4450GSX-PWR+ Switch
Comments on this document? infodev@avaya.com
Table continues...
35