Troubleshooting layer 2 and layer 3
Showing IP OSPF interface VLAN
About this task
Use this procedure to display the OSPF information for each VLAN interface.
Procedure
1. At the ACLI command prompt, enter the show ip ospf interface vlan
2. Review the command output to verify the priority.
Configuring router priority to a value greater than zero
Before you begin
• Access the ACLI VLAN Interface Configuration mode. At the ACLI command prompt, type
enter, type configure terminal, type int vlan <vid>).
About this task
Use the following procedure to configure the router with a priority greater than zero.
174
Troubleshooting
<vid> command.
Example: Priority: 1
Comments? infodev@avaya.com
December 2013