Avaya 5000 Series Troubleshooting Manual page 149

Displaying Proxy ARP using EDM
About this task
You can use EDM to set proxy ARP.
Procedure
1. Navigate to IP Routing > IP > ARP Interfaces.
2. Select an interface.
3. Set desired value in the DoProxyfield.
Displaying proxy ARP using SNMP
About this task
You can use SNMP display proxy ARP.
Procedure
1. Use the snmp walk command on the rcArpExtEntDoProxy object.
2. Review the output for errors.
Enabling or disabling proxy ARP
About this task
You can use the procedures in this section to enable or disable proxy ARP.
By default, ARP is disabled.
Enabling or disabling proxy ARP using ACLI
Procedure
1. Go to the ACLI Global Configuration mode.
2. At the prompt, enter one of the following commands.
Troubleshooting
To return proxy ARP to the default state, at the prompt enter the default ip arp
proxy [enable] command.
• ip arp proxy enable command to enable proxy ARP
ARP not forwarding traffic correctly
December 2013 149