Troubleshooting Layer 3
2. Enter the show ip vrrp interface verbose command.
3. Observe and note the status displayed in the Hold Timer column.
Configuring the virtual router preempt action
Cancels a virtual router holddown action that is in progress.
Procedure
1. Enter VLAN Interface Configuration mode:
enable
configure terminal
interface vlan <1–4094>
2. Enter the ip vrrp <VRID> action preempt command.
Checking the VLAN staus
Check that the VLAN in which VRRP routers are enabled is operational.
Procedure
1. Enter Privileged EXEC mode:
enable
2. Enter the show vlan command.
3. Observe the status displayed in the Active column for the VLAN.
No VRRP master routers in a VLAN
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where there is no VRRP master router within a VLAN.
Checking the system log
Display and observe the system log for VRRP-related error messages.
Procedure
1. Enter Privileged EXEC mode:
enable
2. Enter the show logging command.
Troubleshooting Avaya VSP 7000 Series
96
Comments on this document? infodev@avaya.com
July 2015