Troubleshooting layer 2 and layer 3
Figure 81: Configure an interface to not be passive
Showing IP OSPF interface VLAN
About this task
Use this procedure to display IP OSPF information for each VLAN interface.
Procedure
1. At the ACLI command prompt, enter the show ip ospf interface vlan
2. Review the command output to verify the interface type.
Configuring interface type as broadcast
About this task
If an interface is configured to be passive, it does not send Hello to its connected neighbors,
or process Hello from connected neighbors.
The default OSPF interface type is broadcast.
172
Troubleshooting
<vid> command.
Example — Type: Passive
Comments? infodev@avaya.com
December 2013