Figure 87: Configure send and receive
Showing RIP IP interface
About this task
Use the following procedure to display the RIP interface information
Procedure
1. At the ACLI command prompt, enter the show ip rip interface command.
2. Review the command output to verify that the RIP versions match on the sending
Configuring device RIP versions
About this task
Use the following procedure to configure the device to send and receive RIP packets.
Procedure
1. At the ACLI command prompt, enter the show ip rip interface command to
Troubleshooting
RIP packets are exchanged between devices but no routes are learned
and receiving interfaces.
display the interface information.
December 2013
183