Connector Coding - Siemens SINAMICS DCM Operating Instructions Manual

Control module
Hide thumbs Also See for SINAMICS DCM:
Table of Contents

Advertisement

Additional system components
7.4 Terminal Module TM15
7.4.9

Connector coding

A series of coding elements ("coding sliders") are supplied with each Terminal Module
TM15.
Connector coding
1. Insert at least one coding slider at the required position.
2. Remove the associated coding lug at the connector.
Figure 7-23
To avoid wiring errors, unique coding patterns must be defined for the connectors X520,
X521 and X522.
Possible patterns:
● 3 connectors on one component are encoded differently (i.e. X520, X521 and X522).
● Different component types are encoded differently.
● Otherwise identical components are encoded differently on the same machine,
(e.g. several TM15-type components).
200
Insert a coding slider.
Cut off the coding lug on the connector.
Procedure for encoding a connector
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics dc master

Table of Contents