Siemens SINAMICS DCM Operating Instructions Manual page 260

Commissioning
8.5 Commissioning with the STARTER commissioning tool
Figure 8-9
⇒ Click PG/PC... and set up the interface according to your device configuration.
Buttons Properties..., Diagnostics... and Copy... are now available.
Set S7ONLINE as access point.
Note
Connection via PROFINET IO with CBE20
To establish the connection via the additional module CBE20, see Chapter "General
information about PROFINET IO (Page 459)".
258
Setting up the interface
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A