Siemens SINAMICS DCM Operating Instructions Manual page 604

Control module

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Descriptions of functions

10.32 Diagnostics

Parameterizing and operating the function generator

You operate and parameterize the function generator via STARTER.

Figure 10-92 Function generator

Please refer to the online help for more information about parameterization and operation.

The "Function generator as commissioning tool" button must not be selected!

If this button is still selected, then the message "Error occurred while parameterizing" is

output on STARTER when "Loading the parameterization to the drive" as well as alarm

A02007 on the SINAMICS DCM (Function generator: Drive not SERVO/VECTOR).

SINAMICS DCM Control Module

Operating Instructions, 12/2018, A5E34888669A

Sinamics dc master