Technical Data; Environmental Conditions - Siemens SINAMICS DCM Operating Instructions Manual

Technical data

Note
You can find the technical data for the connectors and terminals in the section titled
"Connecting (Page 55)".
4.1

Environmental conditions

Environmental classes according to EN 60721-3
Table 4- 1 Environmental classes
Use Environmental condition
Operation Mechanical stability
Climatic influences
Biological influences
Hazardous chemical substances
Mechanically hazardous materials
Trans- Mechanical stability
portation
Climatic influences
Biological influences
Hazardous chemical substances
Mechanically hazardous materials
Storage Mechanical stability
Climatic influences
Biological influences
Hazardous chemical substances
Mechanically hazardous materials
Only applies when product is in its original packing
1)
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
Environmental Comment
class
see remark
Vibratory load (test and measuring procedure
•
according to EN 60068-2-6, Fc): Constant
deflection = 0.075 mm at 10 ... 58 Hz
Constant acceleration = 10 m/s² at
58 ... 200 Hz
Shock load (test and measuring procedure
•
according to EN 60068-2-27, Ea):
Acceleration = 150 m/s² at 11 ms
3K3 No condensation, splash water, or icing allowed.
For air temperature, see "Ambient temperature"
below
3B1 -
3C1 -
3S2 -
2M2 Tipping is not permitted.
2K2 Air temperature of -40 °C to +70 °C is permitted
2B1 -
2C1 -
2S1 -
1M2 Tipping is not permitted.
1K3 Air temperature of -40 °C to +70 °C is permitted
1B1 -
1C1 -
1S1 -
4
1)
1)
37