Siemens SINAMICS DCM Operating Instructions Manual page 468

Control module

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Descriptions of functions

10.5 Communication via PROFINET IO

Connecting the PC to the STARTER commissioning tool

You can go online with STARTER in a number of ways, which are illustrated below:

Figure 10-39 Connecting the IO supervisor

SINAMICS does not support routing from PROFIBUS to PROFINET and vice versa.

If a CBE20 Communication Board Ethernet fails (e.g. due to a power failure), then

communication with the subsequent nodes is interrupted at this point.

SINAMICS DCM Control Module

Operating Instructions, 12/2018, A5E34888669A

Sinamics dc master