Siemens SINAMICS DCM Operating Instructions Manual page 289

Alternatively, the download to the target system can also be performed as follows:
● Step 1
Select the menu command Target system > Download > Project to target system
Selection in the toolbar
Note
Your project data has now been transferred to the drive unit. Presently, this data is only in
the volatile memory (RAM) of the drive unit, however, neither saved in the non-volatile
memory (ROM) nor on an optionally inserted memory card (see also Chapter "Memory
card functions (Page 327)").
To save your project data in the ROM and on the optionally available memory card of
your drive unit so that it is protected against power failure, carry out the following steps.
● Step 2
Select the menu command Target system > Target system > Copy RAM to ROM
Selection in the toolbar
Note
The button for copying RAM to ROM can only be activated if the drive unit has been
marked in the project navigator.
Results of the preceding steps
● You have generated a project for your drive unit using the STARTER offline
● You have saved your project data to your PC hard drive
● You have transferred your project data to the drive unit
● You have saved your project data in your drive unit's FLASH memory so that it is backed
up in the event of a power failure
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
8.5 Commissioning with the STARTER commissioning tool
Commissioning
287