Siemens SINAMICS DCM Operating Instructions Manual page 418

Descriptions of functions
10.3 Communication according to PROFIdrive
Error Meaning
value
0x7A Parameter %s [%s]: Write access
only in the commissioning state, data
record base configuration
(device: p0009 = 4).
0x7B Parameter %s [%s]: Write access
only in the commissioning state,
device configuration
(device: p0009 = 1).
0x7C Parameter %s [%s]: Write access
only in the commissioning state,
device download
(device: p0009 = 29).
0x7D Parameter %s [%s]: Write access
only in the commissioning state,
device parameter reset
(device: p0009 = 30).
0x7E Parameter %s [%s]: Write access
only in the commissioning state,
device ready (device: p0009 = 0).
0x7F Parameter %s [%s]: Write access
only in the commissioning state,
device (device: p0009 not equal to 0).
0x81 Parameter %s [%s] must not be
written during download.
0x82 Transfer of master control is blocked
by BI: p0806.
0x83 Parameter %s [%s]: Requested BICO
interconnection not possible.
0x84 Parameter %s [%s]: Parameter
change inhibited
(refer to p0300, p0400, p0922)
0x85 Parameter %s [%s]: Access method
not defined.
0x87 Write job will not be executed..
0xC8 Below currently valid limit.
0xC9 Above currently valid limit.
0xCC Write access not permitted.
416
Remark
–
–
–
–
–
–
–
–
BICO output does not supply float values. The BICO input,
however, requires a float value.
–
–
The write request is rejected because know-how protection
is active.
Modification request for a value that, although within
"absolute" limits, is below the currently valid lower limit.
Modification request for a value that, although within
"absolute" limits, is below the currently valid lower limit
(e.g. governed by the current converter rating).
Write access is not permitted because an access code is not
available.
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
Additional
info
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–