Siemens SINAMICS DCM Operating Instructions Manual page 449

Control module

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Figure 10-29 Configuring the PROFIBUS direct data exchange in STARTER

To connect the drive objects to the process data which is received via direct data exchange,

you also need to connect the appropriate connectors to the corresponding signal sinks. A list

for the connector shows all signals that are available for interconnection.

SINAMICS DCM Control Module

Operating Instructions, 12/2018, A5E34888669A

Descriptions of functions

10.4 Communication via PROFIBUS DP

Sinamics dc master