Product Name - Siemens SINAMICS DCM Operating Instructions Manual

Preface

Product name

The SINAMICS DCM Control Module documentation also uses the following product names:
● SINAMICS DCM
● SINAMICS DC MASTER
These designations are often (frequently in circuit diagrams and topology arrangements)
used in these instructions as an alternative designation for the combination of SINAMICS
DCM Control Module and external converter power unit.
Device firmware version
As these Operating Instructions went to print, SINAMICS DCM Control Modules were being
supplied from the factory with firmware version specified on the inside front page.
However, these Operating Instructions can, in principle, also apply to other firmware
versions.
● Older firmware versions:
It is possible that not all of the functions described here are actually available.
● Newer firmware versions:
It is possible that SINAMICS DCM Control Modules may feature additional functions that
are not described in these Operating Instructions. Do not change any parameters that
you cannot find in the List Manual from their factory setting, and do not give parameters
any values that are not specified in the List Manual.
The firmware version is displayed using r50060[6].
Example:
01010203 displayed on the BOP20 means 01.01.02.03 → Version 1.1, Service Pack 2, Hotfix 3
When required, you can obtain the current firmware from your local Siemens sales office.
Download of the current firmware version for registered users
(https://support.industry.siemens.com/cs/ww/en/view/44029688)
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
3