Parameter Display - Siemens SINAMICS DCM Operating Instructions Manual

Operation
9.2 Parameterizing using the BOP20 (Basic Operator Panel 20)

Parameter display

The parameters are selected in the BOP20 b their number. The parameter display is
reached from the operating display by pressing the "P" key. Parameters can be searched for
using the arrow keys. The parameter value is displayed by pressing the "P" key again. You
can toggle between the drive objects by simultaneously pressing the "FN" key and an arrow
key. You can toggle between "r00000" and the parameter that was last displayed by
pressing the "FN" key in the parameter display.
Figure 9-10
342
Parameter display
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A