How To Enter Lengths Manually - Fluke Versiv Series Technical Reference Handbook

example, all events after the Launch + Tail event have gray
buttons in the Launch column, and all events before that have
gray buttons in Tail column.
 To see the OTDR trace for the events on this screen, tap View
Trace.
Tap SAVE to save your settings.


How To Enter Lengths Manually

When you use launch and tail cords that have APC connectors, it is
possible that the tester will not find the connectors when you try
to set up the launch compensation function. If this occurs, enter
the lengths of the launch and tail cords manually.
You can also use the manual-entry method when you do not have
an adapter to connect the launch and tail cords together.
To enter the launch and tail cord lengths manually
On the home screen, tap the TOOLS icon, then tap Set Launch
1
Compensation.
Set Launch Compensation shows on the TOOLS
menu only when an OTDR module is installed.
Tap Manual Entry, then tap SET.
2
Tap Launch Cord, use the keyboard to enter the length of the
3
launch cord, then tap DONE.
You cannot enter a length less than 120.0 m
(393.7 ft) for a singlemode launch cord or 90 m
(295 ft) for a multimode launch cord.
If you will use a tail cord, tap Tail Cord, use the keyboard to
4
enter the length of the tail cord, then tap DONE.
Chapter 11: The OptiFiber Pro OTDR Module
About Launch and Tail Cords
Note
Note
327