Fluke Versiv Series Technical Reference Handbook page 562

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
A
B
C
D
(after you enter the first and last IDs)
First ID and Last ID: The first and last IDs in a set of sequential

IDs. See "How to Make ID Sets" on page 548.
If you do not enter a Last ID when you make an ID set, the tester
will increment the First ID to make subsequent IDs. When you
use an ID set that does not have a Last ID, the set under IDs
Untested on the CHANGE ID screen shows only the next ID.
The tester does not increment symbols or
accented characters.
Total IDs: The number of IDs in the set. This section does not

show for ID sets that do not have a Last ID.
526
E
Figure 198. CABLE ID SETUP Screen
Note
F
G
GPU56.EPS