Tutorial: How To Use A Project For Tests With Optifiber Pro And Certifiber Pro Modules - Fluke Versiv Series Technical Reference Handbook

Tutorial: How to Use a Project for Tests with OptiFiber Pro and CertiFiber Pro
Tutorial: How to Use a Project for Tests with
OptiFiber Pro and CertiFiber Pro Modules
This tutorial assumes that you completed the tutorial "Make a
New Project" on page 516.
In this tutorial, you will do OTDR tests on both fibers of a duplex
fiber link, then you will add loss/length results to the OTDR results
for the two fibers.
Figures 202 and 203 show the equipment necessary for this
tutorial.
Select launch/tail cords and test reference cords
that have the correct connectors to connect to the
OptiFiber Pro and CertiFiber Pro modules and to
the fiber link or segment.
A
Fiber 1A
Fiber 1B
End 1

Main tester with OptiFiber
Pro module installed

Launch and tail cords (match
the fiber to be tested)
Figure 202. Equipment for the OTDR Project Tutorial
Note
C
B



Chapter 17: Use Projects
E
FI-1000 video probe and fiber
cleaning supplies
AC adapter with line cord (optional)
Duplex fiber link or segment
D
Fiber 1A
Fiber 1B
End 2
GPU159.EPS
535