Use the buttons on the probe or the tester to start the test:
4
Press the button on the probe.
If the FiberInspector test shows on in the test setup panel
on the home screen, tap TEST or press .
On the home screen, tap the TOOLS icon, then tap
FiberInspector.
Insert the probe into the connector.
5
To adjust the focus, turn the dial on the probe clockwise or
6
counterclockwise.
Figure 99 describes the FiberInspector display.
To save the image, tap SAVE.
7
On the SAVE RESULT screen, select End 1 or End 2, make sure
8
the Cable ID and End name are correct, then tap SAVE.
Saved FiberInspector results show these icons for End 1 and End
2:
The Auto Save function does not operate with the
FiberInspector test.
Continuous use of the video probe decreases the
battery life. To increase the battery life, connect
the ac adapter when you use the probe for more
than a few minutes.
Chapter 8: Inspect Fiber Endfaces
How to Do the FiberInspector Test
Notes
223