Fluke Versiv Series Technical Reference Handbook page 204

Hide thumbs Also See for Versiv Series:

Table of Contents

Versiv Series Cabling Certification Product Family

Technical Reference Handbook

Store Plot Data

Table 6. Settings for Coaxial Tests

Select DSX-8000 CableAnalyzer or DSX-5000

CableAnalyzer.

Select a cable type that is correct for the type you will

test. To see a different group of cable types, tap MORE,

then tap a group. To make a custom cable type, see

Nominal velocity of propagation. The tester uses the NVP

and the propagation delay to calculate the length of the

The default value is defined by the selected cable type

and is the typical NVP for that cable type. To enter a

different value, tap the NVP panel, then tap

on the NVP screen to increase or decrease the value.

To find the actual value for a cable, connect a known

length of the cable to the tester, tap MEASURE on the

NVP screen, then change the NVP until the measured

length matches the known length. Use a cable at least

30 m (100 ft) long.

When you increase the NVP value, the calculated length

Select the correct test limit for the job. To see a different

group of limits, tap MORE, then tap the name of a

: The tester does not save plot data for insertion

loss or for the HDTDR analyzer. You can see the plots

before you save the test and exit the results screen. The

saved results show insertion loss measurements in a table

and do not include the HDTDR plot.

: The tester saves plot data for the insertion loss

test and for the HDTDR analyzer.

Show Quick Links

Table of Contents