Enter Commands; Common Commands - Fluke 3130-G2M User Manual

3130
Users Manual
Error Number
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114

Enter Commands

Commands for the Product can be entered in upper or lower case. There is a minimum of
one space necessary between the command and parameter. All other spaces are optional.
Most of the commands for the Product are sequential. Any overlapped commands will be
shown as such. This section describes each of the commands and their general use, which
will include any parameters that can be entered with the command as well as what the
output of the command is.

Common Commands

*CLS
Clears the error queue. Also ends all pending operations. When you write programs, use
this command before each procedure to prevent buffer overflow.
*IDN?
Shows the manufacturer, model number, and firmware revision of the Product.
For example:
*IDN?
Shows Fluke, 3130 0, 1.00
36
Table 6. Error Codes
A non-numeric entry was received where it should be a numeric entry
Too many digits entered
Invalid units or parameter value received
Entry is above the upper limit of the allowable range
Entry is below the lower limit of the allowable range
A required command parameter was missing
An invalid command parameter was received
Pressure not selected
Invalid sensor type
Pressure module not connected
An unknown command was received
Bad Parameter received
The serial input buffer overflowed
Too many entries in the command line
The serial output buffer overflowed
Error Description