Fluke Versiv Series Technical Reference Handbook page 90

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
You can select settings for any module that the
tester can use. It is not necessary to install a
module before you set up a test for that module.
Test Type: Make sure the Test Type is SmartLoop OTDR

(Auto).
 Bi-directional: Tap the On/Off control to make it show
On.
Wavelengths: You can do tests at one or all of the

wavelengths that the fiber type supports. For this tutorial,
select all available wavelengths.
Fiber Type: Select the type of fiber you will test. The FIBER

TYPE screen shows the last 10 types of fiber that were
selected.
If you do not see the necessary fiber type, tap MORE, tap the
name of a Fiber Group, then tap a fiber in the group.
 Fiber Type Settings: Tap this item to see the index of
refraction (IR) and Backscatter values for the Fiber Type
you selected.
Test Limit: The test limit specifies the limits for

measurements so that the tester can give a PASS or FAIL
result to the test. The TEST LIMIT screen shows the last 10
limits that were selected.
For this tutorial, select General Fiber. If you do not see this
limit on the TEST LIMIT screen, tap MORE, tap
Miscellaneous, then tap General Fiber.
On the TEST SETUP screen, tap SAVE.
2-6
On the CHANGE TEST screen, tap the SmartLoop OTDR test
2-7
you made, then tap USE SELECTED.
For more information on settings, see "Settings for OTDR Tests"
on page 310.
54
Note