How To Use The Talk Function - Fluke Versiv Series Technical Reference Handbook

How to Use the Talk Function

If you have two testers and two DSX CableAnalyzer modules, you
can use the talk function to talk to the person at the other end of
a twisted pair link.
The talk mode does not operate during tests.
To use the talk function
Connect the main and remote testers together through a link
1
that has one or more good wire pairs.
Connect headsets to the headset jacks on the testers (see
2
Figure 21 on page 70).
Press the button on one of the headset microphones or press
3
 on the remote tester, then speak into the microphone.
When the talk function is on,
on the main tester. On the remote tester, the TALK LED is on.
To adjust the volume at the main tester, press the button on
4
the headset's microphone as necessary, or move the slider
control in the Talk Enabled window.
To adjust the volume at the remote tester, press  or the
button on the headset's microphone as necessary. The LEDs on
the remote show the volume level.
To turn off the talk function, hold down the button on one of
5
the headsets or hold down  on the remote tester.
Chapter 3: Certify Twisted Pair Cabling
How to Use the Talk Function
Note
shows at the top of the screen
157