Table of Contents
Advertisement
To Replace the FPD
WA RNING
Maintaining Your GC
+
Ignitor
1
Gather the following:
•
Ignitor replacement kit. (See
the FPD
•
Torx screwdrivers, T-20 and T-10
•
5/16-inch nut driver (or wrench)
Prepare for maintenance. Maintenance > Instrument > Perform
2
Maintenance > Maintenance Mode > Start Maintenance. Wait for
the GC to become ready.
Be careful! The detector may be hot enough to cause burns. If the
detector is hot, wear heat-resistant gloves to protect your hands.
3
Remove the FPD cover. (See
page 151.)
4
Loosen the collet screw holding the cable assembly to the
ignitor. Remove the collet and cable assembly.
5
Use a nut driver to loosen and remove the glow plug.
•
If using a 5/16-inch wrench, you may need to remove the
exit tube assembly using a T-10 Torx driver
+"
on page 146.)
"To Remove the FPD
Maintaining the FPD
"Consumables and Parts for
+ Cover"
7
+
on
153
Advertisement
Table of Contents
