What The Iw Does And Does Not Do; Electronic Worksheets And Templates - Avaya G700 Installation And Upgrades

The IW ships with the S8300 Media Server and is available on the S8300 Media Server's Web interface
home page. The most recent version of IW, as well as its documentation, can be accessed online at
http://support.avaya.com/avayaiw
Note: To use the IW, Communication Manager Release 1.1.2 or later must be running
on the primary controller media server (S8300 or S8700). If the correct release of
Communication Manager has not been installed on the media server, you need to
upgrade the software before you begin using the IW.

What the IW Does and Does Not Do

The IW does not automate all tasks in an S8300 Media Server installation.
Of the tasks described in this document, the IW automates the following:
• "Transfer Files from a CD or Hard Drive of Laptop" on page 99
• "Install New Software on the S8300" on page 101
• "Configure the G700 Media Gateway" on page 124
• "Configure an X330 Expansion Module", which is a subtask of
Gateway" on page 124
• "Administer Network Regions" for an S8300 Media Server as primary controller, which is a
subtask of "Administer Communication Manager" on page
Note: The IW administers the S8300 network region as the default, 1.
• "Administer the Media Gateway" on page 153
Note: In addition, you can use the IW to upgrade S8300 software or G700 firmware on a
previously-installed system.
You must perform the following tasks manually, even though you are using the IW:
• Install all hardware
• Tasks in "Before Going to the Customer Site" on page 92
• "Install Communication Manager Patch Files from Your Laptop, if Any", which is a subtask of
"Install New Software on the S8300" on page 101
• Set custom LSP transition points when the defaults are not adequate (see Set the LSP Transition
Points on page 84)
• Any tasks related to adding LSPs to the S8300 primary controller you are installing, as documented
in "Administer Communication Manager" on page
• Any tasks related to administration of the primary controller in
Manager" on page 139
• "Set Up SNMP Alarming on the G700" on page
• "Configure an X330 Expansion Module (If Necessary)" on page 131

Electronic Worksheets and Templates

To allow the IW to automatically configure and install the system, you get the following files from the
project manager and load them onto your laptop:
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
1 Roadmap and Reference: Wizards for Installations and Upgrades
and its subtasks
and its subtasks
139:
157, if required
and its subtasks
"Configure the G700 Media
139.
"Administer Communication
25