Optical Drive: Wait For System To Refresh (High/Critical Reliability Only); Set Spe B And Tone-Clock B To Active (High/Critical Reliability Only) - Avaya DEFINITY Server R Manual

Phase 1 Hardware Replacement
Optical Drive: Wait for System to Refresh
(High/Critical reliability only)
1. Type status spe and press
interchange. When it is ready,
The standby refreshes after 5 minutes. If the fields display something other than
the above, see the appropriate maintenance sections.
2. Verify that the disk (disk drive) and removable media on both SPEs are in
service.
Set SPE B and Tone-Clock B to Active
(High/Critical reliability only)
1. Type reset system interchange and press
active SPE. This takes about 5 minutes.
2. Type set tone-clock 1b and press
to SPE B.
3. Type status port-network 1 and press
has moved to SPE B. Make sure the YELLOW LED on the active tone
clock is flashing.
If the Tone-Clock has not migrated to the carrier B after 1 minute, then a
Tone-Clock problem exists. Refer to the TDM-CLK maintenance object to
resolve any problems.
4. Type status spe and press
For high or critical reliability systems:
If the fields display anything other than the above, see the appropriate
maintenance sections.
555-233-115
The Standby Refreshed field shows yes
The Standby Shadowing field shows on
The Standby Handshake field shows up
NOTE:
This takes 1 minute to complete. If SPE A (standby) is not refreshed,
repeat the command until this condition is met.
The Standby Refreshed field shows yes
The Standby Shadowing field shows on
The Standby Handshake field shows up
to make sure the active side is ready for
Enter
to force SPE B to be the
Enter
to move the tone clock from SPE A
Enter
to verify that the Tone-Clock
Enter
to check the health of the SPE.
Enter
Issue 5 October 2002
2-29