Configure Qos; Configure Subnet Roaming - Avaya Communication Server 1000 Installation And Commissioning Manual

desired. The values in the command
example are valid, but other values can also
be used.
Create a server group.
Associate server group with an SSID
configured for WPA2-Enterprise security
using a server group as an external RADIUS
server.

Configure QoS

In addition to QoS parameters present in the radio and service profiles, there are system-
wide settings. Only ingress (packets from the wire side of the switch) needs to be configured.
Table 38: Common Parameters
Set COS/DSCP Mappings for Voice packets.
The specific values depend on how the call
server is configured. Common values for
DSCP values are 46 and 48.
Set COS/DSCP Mappings for Control
packets. The specific values depend on how
the call server is configured. Common values
for DSCP values are 26 and 40.

Configure Subnet Roaming

If more than one MX switch is used, then subnet roaming needs to be configured.
To set up subnet roaming between two switches, a mobility domain must be configured on both
switches. Choose one of the switches to be the seed MX switch. The IP addresses used in
mobility domain configuration must use the system IP address of each switch.
The following commands are performed on the seed MX switch:
Avaya WLAN IP Telephony Installation and Commissioning
Purpose
Purpose
Command
timeout 5 retransmit 3 deatime
0 key <shared secret key>
set server groups CiscoACS
members CiscoACSBoulder
set authentication dot1x ssid
<SSID name> **pass-through
CiscoACS
Command
set qos dscp-to-cos-map <DSCP
value> cos 6
set qos dscp-to-cos-map <DSCP
value> cos 4
Common Parameters
November 2010 149