WLAN Application Gateway 2246
Application Server can be accomplished by a direct connection (RS-232) or through the
Ethernet connection. Only one of these connections can be used at one time.
The IP address of the WLAN Application Gateway 2246 must be configured during initial
configuration. After the IP address is established, the WLAN Application Gateway 2246 can
be accessed by the Application Server through the RS-232 port or through the LAN using
Telnet.
Figure 24: WLAN Application Gateway 2246 connections
System overview
At a typical site, the WLAN Application Gateway 2246 is connected to the Ethernet switch
through an RJ-45CAT 5 cable. The Application Server is connected through the RS-232 port.
The client's system can include a LAN and its Application Server with a TAP connection to a
communications device such as a paging controller.
188
Avaya WLAN IP Telephony Installation and Commissioning
November 2010