Connecting The Aps; Connect To The Wlan Ip Telephony Manager 2245 - Avaya Communication Server 1000 Installation And Commissioning Manual

WLAN IP Telephony Manager 2245 configuration
6.
7.
In the initial configuration of the WLAN IP Telephony Manager 2245, the IP addresses and the
maximum number of active calls per AP must be configured. Later, you can use Telnet to
configure the IP address of the TFTP Server where the software files are located and the
hostname.

Connecting the APs

As the APs are connected to the network, they automatically find the controller through the
LWAPP discovery algorithms. The Dynamic Host Configuration Protocol (DHCP) server
assigns each AP an IP address.
Important:
You can configure a DHCP server to run on a remote PC for a small deployment. However,
for large-scale deployments, an enterprise-grade DHCP server must be used.
The ap-manager and management interfaces configuration include the DHCP server you have
configured. Alternately, you can configure the DHCP server internally on the controller to hand
out leases to the connected clients. The instructions for doing so are included at the end of
this document.
Important:
The WLC DHCP server does not lease addresses to the AP.
Perform the following procedure to connect APs.
Procedure steps
1. From the main menu, choose Controller.
2. In the navigation pane, click Interfaces. Verify that the proper IP addresses are
3. Under Interface Name click management.
4. Under DHCP Information, enter the IP address of the Primary DHCP Server.
5. Repeat this step for the ap-manager interface.
6. Click Apply to save the changes.

Connect to the WLAN IP Telephony Manager 2245

The initial connection to the WLAN IP Telephony Manager 2245 must be made through a serial
connection to establish the WLAN IP Telephony Manager 2245 IP address. After the IP address
132 Avaya WLAN IP Telephony Installation and Commissioning
Configure the WLAN IP Telephony Manager 2245
Change the password
assigned to the interfaces.
on page 141.
on page 138.
November 2010