Configure Radio Profile - Avaya Communication Server 1000 Installation And Commissioning Manual

WLAN IP Telephony Manager 2245 configuration
These packets are not forwarded through the
Mobility Exchange Switch when IGMP
snooping is enabled.

Configure Radio Profile

The radio profile configuration is described below and divided between the two types of QoS
supported by the handsets. The handsets and an AP radio can only support one type of QoS
mode (WMM-Power Save or SVP) at one time. There is a section for configuring the AP radios
common to both QoS modes and for each of the QoS modes.
The string <profile name> should be substituted with the radio profile name desired. The
example configuration in the chapter uses wmmps for the WMM-Power Save QoS mode radio
profile and svp for the SVP QoS mode radio profile.
Table 27: Common Parameters
Setting the DTIM interval to 2.
Prevent the AP form going off-channel to
scan.
Disable auto tune power.
Table 28: WMM Parameters
Enalbe WMM-Power Save (UAPSD).
Enable WMM QoS.
Enable Voice/Video access control, disable
policing, and configure max-utilization for
each of the WMM access category queues.
144 Avaya WLAN IP Telephony Installation and Commissioning
Purpose
Purpose
Purpose
Command
Command
set radio-profile <profile
name> dtim-interval 2
set radio-profile <profile
name> rf-scanning channel-
scope operation set radio-
profile <profile name>
active-scan disable
set radio-profile <profile
name> auto-tune power-config
disable
Command
set radio-profile <profile
name> wmm-powersave enable
set radio-profile <profile
name> qos-mode wmm
set radio-profile <profile
name> cac voice mode enable
set radio-profile <profile
name> cac video mode enalbe
set radio-profile <profile
November 2010