Avaya Communication Server 1000 Installation And Commissioning Manual page 192

WLAN Application Gateway 2246
Follow the steps in
WLAN Application Gateway 2246.
Installing the WLAN Application Gateway 2246
1. Place the WLAN Application Gateway 2246 on a shelf or convenient location.
2. Connect the power plug from the WLAN Application Gateway 2246 power adapter to
3. Plug the power adapter into an outlet or outlet strip.
4. Apply power to the WLAN Application Gateway 2246.
5. Ensure that the ERROR LED is off and LED 1 is blinking.
Configuring the WLAN Application Gateway 2246 IP address
You must connect to the WLAN Application Gateway 2246 through a serial connection to
configure the IP address and the network parameters. After this is done, you can perform
administration and further configuration through a Telnet connection using the Administration
Console.
Follow the steps in
page 192 to make a serial connection to the WLAN Application Gateway 2246.
Connecting to the WLAN Application Gateway 2246 through a serial port
1. Using a DB-9 female, null-modem cable, connect the WLAN Application Gateway
2. Run a terminal emulation program (such as HyperTerminal) or use a VT-100
192 Avaya WLAN IP Telephony Installation and Commissioning
Installing the WLAN Application Gateway 2246
Important:
The WLAN Application Gateway 2246 is physically connected to the Ethernet
switch and can be placed in any convenient location within 325 ft (100 m) of the
switch. It can also be rack-mounted.
the power jack on the front (or rear) of the box.
Important:
Use only the power adapter provided by Avaya.
Connecting to the WLAN Application Gateway 2246 through a serial port
2246 to the serial port of a terminal or PC.
terminal with the following configuration:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
on page 192 to install the
November 2010
on