Configure Failover Field Descriptions - Avaya Aura System Platform Installing And Configuring

System Platform High Availability Failover
3. On the Failover – Current status of failover components page, fill up the fields. See
4. Click Create.
5. Click Start Failover only after the system completes the failover creation operation.
6. Log on to System Platform Management Console
7. Click Server Management > Failover.

Configure Failover field descriptions

Name
Remote cdom IP address
Remote cdom user name
Remote cdom password
Primary network interface
Crossover network interface
86 Installing and Configuring Avaya Aura
fields.
The start failover operation blocks all the connections to the System Platform
Management Console, and so you must log in again after the start failover operation
is complete.
You can check the status of the failover components in the Failover – Current status
of failover components page and ensure that DRDB (Distributed Redundant Block
Device) is synchronizing the hard disks of the two servers.
Tip:
When the system finishes the disk synchronization process, you can increase or
decrease the speed of the sync with a slider bar provided on the console. The
default value of this rate is 30 MB. If you set the value too high, it may affect the
performance of the virtual machines running on the active server.
™
System Platform
Description
The secondary Console Domain IP address.
User name for Console Domain.
The password for Console Domain.
The required Ethernet NIC.
The required Ethernet NIC.
April 2010